How can we help you today?

Start a new topic
Discussions FAB 3000 (Gerber-CAM Software)
CAM Engineering and DFM Questions 1082

Online Support and FAQ for Gerber and CAM Software

S
I tried to import a step file, but fab will not detect the holes, because the are "hidden" between two other layers.
Posted by Simon Garrison, about 7 years ago
S
How do I create a Test Point?
Posted by Simon Garrison, about 7 years ago
S
I have a gerber file with all holes for my Drill, and assigned the Layer type as Drill Thru-hole. However when I go to export the Drill file, I receive a message that I can't. Why?
Posted by Simon Garrison, about 7 years ago
S
When I import a 3D STEP file into FAB 3000, all I see is a rectangle. What happened?
Posted by Simon Garrison, about 7 years ago
S
How do I find the closes distance between two nets?
Posted by Simon Garrison, about 7 years ago
S
When exporting my Gerber, there were hundreds of additional Circles placed everywhere - why?
Posted by Simon Garrison, about 7 years ago
S
After importing my NC Rout file, I noticed an invalid plunge/retract point which I need to remove. I tried using Join Wizard (Automatic) to remove it, however is there an easier way.
Posted by Simon Garrison, about 7 years ago
D
How to update Fab 3000?
Posted by Danny Carr, about 7 years ago
S
How do I trim back an existing ground plane layer, I tried the trim command but that didn’t work? Would this be by dragging the vertexes (which seem to work)?
Posted by Simon Garrison, about 7 years ago
S
I was able to add the mouse bites but I haven’t gotten them where they need to be (75% inside of board outline) Would this be offset I need to adjust?
Posted by Simon Garrison, about 7 years ago