CAM Engineering and DFM Questions (1122)

Open window of FAB starts bigger than my monitor screen.

Posted over 7 years ago by Simon Garrison

How do I modify the Width for all Zero width traces?

Posted almost 8 years ago by Simon Garrison

Find missing mask openings

Posted almost 8 years ago by Ludvig Sjöholm, Last Reply by Simon Garrison over 7 years ago

I need to perform Netlist extraction and DRC checks with very small geometries (with 1 micron trace and spacing). Can FAB 3000 support these micro dimension requirements?

Posted almost 8 years ago by Simon Garrison

Can I disable Rout Compensation during export?

Posted almost 8 years ago by Simon Garrison

In the "Window" menu bar, I can not see the "NC Editor Mode" in the drop down menu. I am using FAB 3000 Version 8.

Posted almost 8 years ago by Simon Garrison

How can I merge Gerber files together in FAB 3000?

Posted almost 8 years ago by Danny Carr

I am currently a FAB 3000 Version 7 user. How do I Upgrade to Version 8?

Posted almost 8 years ago by Simon Garrison

Convert Gerber and Drill to an Intelligent ODB++ file in 5 Steps.

Posted almost 8 years ago by Simon Garrison

I couldn't find was a proper tool to measure the trace length of a net. Any advice on how this can be done best?

Posted almost 8 years ago by Simon Garrison