CAM Engineering and DFM Questions (1114)

When I import a 3D STEP file into FAB 3000, all I see is a rectangle. What happened?

Posted almost 8 years ago by Simon Garrison

How do I find the closes distance between two nets?

Posted almost 8 years ago by Simon Garrison

When exporting my Gerber, there were hundreds of additional Circles placed everywhere - why?

Posted almost 8 years ago by Simon Garrison

After importing my NC Rout file, I noticed an invalid plunge/retract point which I need to remove. I tried using Join Wizard (Automatic) to remove it, however is there an easier way.

Posted almost 8 years ago by Simon Garrison

The drill file generated has many digits without any points or commas. How can I add a Decimal places to the drill file output?

Posted about 8 years ago by Simon Garrison

How can I change the workspace tab name?

Posted over 8 years ago by Mariusz, Last Reply by Simon Garrison about 8 years ago

Moving around in FAB 3000

Posted about 8 years ago by Danny Carr

Where can I find the sample LUA apps installed with FAB 3000?

Posted about 8 years ago by Simon Garrison

I was able to add the mouse bites but I haven’t gotten them where they need to be (75% inside of board outline) Would this be offset I need to adjust?

Posted almost 8 years ago by Simon Garrison

How do I trim back an existing ground plane layer, I tried the trim command but that didn’t work? Would this be by dragging the vertexes (which seem to work)?

Posted almost 8 years ago by Simon Garrison