Panel Setup - Text Labels

Add Text Label to the active Panel.

• Text Label:  Enter the text you require on the panel.  All dynamic Text variables are fully supported, https://support.numericalinnovations.com/support/discussions/topics/14000018603
• Font:   Choose the font you wish for the Text label.  FAB 3000 supports almost any TrueType or AutoCAD SHX font, so if you don't see a specific font you require it can be compiled into a FAB 3000 font file (*.fnt).  https://support.numericalinnovations.com/support/discussions/topics/14000003029
  • Barcodes are supported.  FAB 3000 comes with several Bar Code fonts already included.  You can compile any existing TrueType font into a FAB 3000 font file (*.fnt) that may be used within your panel, https://support.numericalinnovations.com/support/discussions/topics/14000003119
• Height:  Enter the Text height you require.
• Insert Point X, Y:  Assign the Lower-left insert point for the text.
• Mirror:  If checked Text will be mirrored Horizontally (about the Y axis).
• Negative:  If checked text will be clear.  Make sure text is over an existing metal area or else it will appear invisible.
• Align:  Align text label about the Insert Point (X,Y).  There are 9 alignment values available, and the default is LL (Lower Left).
  • LL     Lower Left.
  • CL    Center Left . 
  • UL    Upper Left . 
  • LC    Lower Center. 
  • CC    Center Center.   (exact middle of text)
  • UC     Upper Center. 
  • LR     Lower Right. 
  • CR     Lower Right. 
  • UR     Lower Right. 
• Layer(s):  Select the layers for the Text to appear.

IMPORTANT:  Relative Panel Coordinates are Recommended: 

You may use Relative Panel Coordinates requires the at-sign @    (See below link for examples)

• Panel Setup: Using Relative Panel Coordinates

0 Votes