-
Is there a possibility after an Gerber file is loaded, to export to a bmp or tiff by specifying the real pixel size?
-
Teardrop problem in IPC-2851
-
DXF Import - ARC with too many little segments
-
What is the current version of DFM Now! V8?
-
When I set the "Minimum Clearance: Plated Drills to Copper" test condition to 5.1 mils, FAB3000 does not report any issues, even though I have spacing of 4.9 mils in my design.
-
When I open FAB3000 (or load a series of Gerber files), the left column that shows the layers panel and aerial view is not shown.
-
When I run a DFM check, the software becomes unresponsive.
-
In some multi-panel layouts I have the requirement to add tabs at specific places so they are accessible after component placement. Can I add tabs in the panel layout or just in jobs?
-
Add Tabs - Tab drill hits for the mouse bites reside on the rout file and not the drill file. How do I place the drill hits for the mouse bits on another layer (beside route)?
-
print to PDF files not sharp (clear)
Sorted by