CAM Engineering and DFM Questions (1122)

I have read and viewed how one can compare two PCB files for differences, however I am confused at the Job Tabs once both are imported.

Posted over 6 years ago by Simon Garrison

I am getting hundreds of shorts when I run Netlist Compare on my Gerbers - however if I import an ODB++ and run Netlist Compare there are NO shorts (on the exact same design) - Why?

Posted over 6 years ago by Simon Garrison

We manufacture SMT stencils, and I'd like to be able to use Query or List any SMT pads to quickly determine their Area and Aspect ratios. Do you have a solution?

Posted almost 7 years ago by Simon Garrison

During ODB++ Import, I'd like to substitute the component Part Number with a property like "CDS_LW_PART_NUMBER". Can this be done?

Posted almost 7 years ago by Simon Garrison

I had one question regarding gerber comparison that I would like to perform on the FAB 3000.

Posted almost 7 years ago by Simon Garrison

How do I rename layers in FAB 3000?

Posted almost 7 years ago by Simon Garrison

Does FAB3000 have features that help selecting stencil thickness, for exampel high-lighting pads with area ratio or aspect ratio below a specified value or high-lighting pads with a width smaller than a specified value (which indicates the number of solde

Posted almost 7 years ago by Simon Garrison

I try to design a stencil using FAB 3000 ,but I did not know how I can generate square aperture from circular aperture in case fine pitch BGA.

Posted almost 7 years ago by Simon Garrison

When using Boolean Wizard to Subtract two layers, it crashed. Can you help?

Posted almost 7 years ago by Simon Garrison, Last Reply by Simon Garrison 8 months ago

I am trying to subtract elements from Layer 1 from elements from Layer 2 to create holes in Layer 2 that match the elements in Layer 1. I can use the Boolean Subtract function for individual objects, but I cannot select multiple (all) objects from Layer

Posted almost 7 years ago by Simon Garrison