ACE Translator 3000 (CAD to EDA Translator) (390)

I could use some help to produce an NC Drill file from a PDF.

Posted over 13 years ago by Numerical Support Team, Last Reply by Danny Carr over 7 years ago

I have problems when entering my activation code for ACE 3000. Can you solve it?

Posted about 14 years ago by Numerical Support Team, Last Reply by Danny Carr over 7 years ago

I am converting from BMP to DXF. Is there an option to reduce the amount of vectors/objects/nodes?

Posted over 5 years ago by Simon Garrison

I converted a batch of gerber files to a step file, but they all were put on the same layer/plane. How can I manipulate it to show them on a 3D board?

Posted over 6 years ago by Simon Garrison

I noticed that my drill file (.drl) has other dimension (mm) than my other gerber files mainly all the other layer files (mil). I can successfully convert the gerber files to ODB++with only one exception; that is my drill "layer" does not match properly.

Posted over 6 years ago by Simon Garrison

When performing a 3D STEP conversion, I do not see the option to setup the Z-base, as demonstrated in your Youtube videos. Am I using the wrong version?

Posted about 6 years ago by Simon Garrison, Last Reply by Simon Garrison about 6 years ago

I have used ACE to generate a 150GB monochrome BMP file, however all image viewers fail.

Posted almost 6 years ago by Simon Garrison

When will the new ACE Version 8 be Released?

Posted over 5 years ago by Simon Garrison

How do you define drawing unit in ACE Editor? Do you define it?

Posted about 5 years ago by Simon Garrison

Converting Gerber to G-Code for 3D Printing

Posted almost 5 years ago by Simon Garrison