Numerical Innovations - Help Center

I would appreciate, if you could advise me on one  matter (of course, I searched on community forums, but I could not find an answer).

Namely, I could import pdf and export to dxf successfully for almost all layers. However, there are a couple of layers, which I could not manage.

Namely, FAB 3000 interprets one layer as two layers.

Yet, it is desirable to have one layer, in accordance with the original document.

I would greatly appreciate your support.

Respectfully,

Vladimir.

Hello Vladimir,

Thanks for your question.

To get the results you require during PDF Import, please set the following option:

•  Map Layers:  to "Merge All To a single Layer"
• Fill Area Mode:  "Treat White Areas as Holes (Auto-Detect)"  or  "Treat White Areas as Holes (De-embed)"

Best regards,

Simon