Load various forms of gerber. Establish the dimensions of the pcb. Zero the x y coordinate counter. Mark a point for editing

Posted over 13 years ago by Numerical Support Team

Post a topic

Numerical Support Team

Our main use of the software is the following. Perhaps you could help us with some of these commands.

1. Load various forms of gerber - This works fine

2. Establish what each layer is. This works fine

3. Establish the dimensions of the pcb We would like to be able to snap the cursor to the a point on the board, for example the corner marker, then move to somewhere else on the board for example the diagonal corner marker, and snap to that. We are struggling a bit with this. What would be the best way ?

4. Zero the x y coordinate counter. can this be done

5. Mark a point for editing how do you do this

0 Votes

1 Comments

Numerical Support Team posted over 13 years ago

>>> For items 1-5 check out this movie tutorial:
http://screencast.com/t/GGGKeVeD

0 Votes