I exported a exc drill file after editing it in Fab3000, looks good. But, I cannot find the drill sizes in the file, can you point them out?
N
Numerical Support Team
started a topic
about 12 years ago
I exported a exc drill file after editing it in Fab3000, looks good. But, I cannot find the drill sizes in the file, can you point them out?
1 Comment
N
Numerical Support Team
said
about 12 years ago
[QUOTE]I exported a exc drill file after editing it in Fab3000, looks good.
But, I cannot find the drill sizes in the file, can you point them out?
Fille attached
Love your products.
Best, Mike[/QUOTE]
Hello Mike,
Thank you for contacting support.
Actually that file is a "Gerber file" with a bunch of "Square" polygons and not a Drill file. To create a drill file from a Gerber, you need to do the following:
1. Convert those "square polygons" to round flashes. Flashes are required when converting to Drill becauase they have a Center & Width (just like drill holes).
Numerical Support Team