Ive looked and cant find cutter compensation in FAB 3000 is this a feature?
N
Numerical Support Team
started a topic
about 16 years ago
To assign cutter compensation to routed paths, please perform the following:
1. Place FAB 3000 into NC Editor Mode (menu: Windows | NC Editor Mode) 2. Select the rout, and go to menu: Edit | NC Properties... 3. Then assign "Compensation Side".
Note: Make sure to turn Fill Mode on to view the compensation offsets (menu: View | Fill)
Numerical Support Team
1. Place FAB 3000 into NC Editor Mode (menu: Windows | NC Editor Mode)
2. Select the rout, and go to menu: Edit | NC Properties...
3. Then assign "Compensation Side".
Note: Make sure to turn Fill Mode on to view the compensation offsets (menu: View | Fill)