How can we help you today?

Start a new topic
Discussions FAB 3000 (Gerber-CAM Software)
CAM Engineering and DFM Questions 1081

Online Support and FAQ for Gerber and CAM Software

N
Can I convert legacy Film to Gerber files with FAB 3000?
Posted by Numerical Support Team, over 9 years ago
N
The “Layer Detection Table…” doesn’t seem to take more comma entries after “comp_+_top & bot”” for “Components Top” and “Components Bottom”.
Posted by Numerical Support Team, over 9 years ago
N
I would like to import a Centroid file and check it against my Gerbers. Is that possible with FAB 3000?
Posted by Numerical Support Team, over 9 years ago
N
Is there a way to update the Gerber files after the apertures are updated?
Posted by Numerical Support Team, over 9 years ago , Last Reply by Numerical Support Team over 9 years ago
N
Convert DXF to Gerber, and then I noticed small gaps in the traces when performing a DFM Check.
Posted by Numerical Support Team, over 9 years ago
N
Import DXF, perform Step/Repeat, and export to Postscript file (EPS) which is fully compatible with Xerox Inkjet.
Posted by Numerical Support Team, over 9 years ago
N
RS-274-D Gerber file - Thermal Apertures
Posted by Numerical Support Team, over 9 years ago , Last Reply by Numerical Support Team over 9 years ago
N
When I measure it is in English,…how do I change that to metric ?
Posted by Numerical Support Team, over 9 years ago
N
I haven't figure out how to get a border defined. Without that I can't get it to do much. Spent about 30 minutes on it and then ran out of time.
Posted by Numerical Support Team, over 9 years ago
N
How do I extract a board outline from the gerbers?
Posted by Numerical Support Team, over 9 years ago