How can we help you today?

Start a new topic
Discussions FAB 3000 (Gerber-CAM Software)
CAM Engineering and DFM Questions 1081

Online Support and FAQ for Gerber and CAM Software

N
I want to swap then so that the pin that goes to power will go to ground and vice versa. How do I change which plane the via go to?
Posted by Numerical Support Team, over 9 years ago , Last Reply by Numerical Support Team over 9 years ago
N
How can I use FAB 3000 to Generate a PDF showing all DFM errors on my PCB?
Posted by Numerical Support Team, over 9 years ago
N
Can you illustrate how to perform Netlist Compare on my Gerbers?
Posted by Numerical Support Team, over 9 years ago
N
Do you have a tutorial showing me how to merge different PCB designs onto a single panel?
Posted by Numerical Support Team, over 9 years ago
N
How can I Eliminate the horizontal rail of my Panel to get better efficiency?
Posted by Numerical Support Team, over 9 years ago
N
Can you show me how to create a complete Panel with Routs, Tabs, Fiducials, Tooling Holes, Rails, and Venting?
Posted by Numerical Support Team, over 9 years ago
N
On the Linux stations were the tool runs successfully, the following error is displayed - libGL error: failed to load driver: swrast
Posted by Numerical Support Team, over 9 years ago
N
On some Linux stations I get the following error- “fab3000: symbol lookup error: /opt/numerical/fab3000v7/lib/fox.so: undefined symbol: clock_gettime”
Posted by Numerical Support Team, over 9 years ago
N
I recently downloaded FAB 3000 for Linux and noticed it was a few versions behind the Windows. Can you tell my why?
Posted by Numerical Support Team, over 9 years ago
N
When using the Auto Rout feature, the Rout path was compensated on the inside of my PCB - not the outside. How can I fix this?
Posted by Numerical Support Team, over 9 years ago