Yes. The best thing to do is add these items to the Panel Setup - (i.e. automate the placement of these objects). However if you wish to add manually add in seperate vias or pads with a drill hole, perform the following:
1. Display your final panel, then go to menu: Window | NC Editor Mode.
Note: This will place FAB 3000 into NC editor mode, so you can add drill holes and/or routs, etc.
2. Go to menu: Add | Drill Hit
Note: Make sure the active layer is a Drill layer, and that you have chosen the drill hole size you want to use.
Note: To add drill hole sizes, goto menu: Setup | NC Tools Table...
3. Place your drill holes.
4. Then export the drill file, and you'll be fine.
Note: This will place FAB 3000 into NC editor mode, so you can add drill holes and/or routs, etc.
2. Go to menu: Add | Drill Hit
Note: Make sure the active layer is a Drill layer, and that you have chosen the drill hole size you want to use.
Note: To add drill hole sizes, goto menu: Setup | NC Tools Table...
3. Place your drill holes.
4. Then export the drill file, and you'll be fine.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article