When converting dxf to gerber files, is it possible to set one width for lines/arcs and another width for text?
N
Numerical Support Team
started a topic
over 16 years ago
During DXF/DWG Import control the default width for Text, go to tab "Text" and then adjust Text Stroke Width | Use Width (Mil). Also, change the Mode for each AutoCAD font to "Stroke", in the font table (see image below).
Note: There are three modes for importing DXF fonts: Ratio, Stroke, Polygon. Ratio - Determine text stroke width (Text Height/Ratio) Stroke - Use text stroke width Polygon - Draw outline and fill as polygon (works great for TrueType fonts).
Numerical Support Team
Note: There are three modes for importing DXF fonts: Ratio, Stroke, Polygon.
Ratio - Determine text stroke width (Text Height/Ratio)
Stroke - Use text stroke width
Polygon - Draw outline and fill as polygon (works great for TrueType fonts).