How can we help you today?

Start a new topic
Discussions FAB 3000 - Gerber/CAM Software
FAB 3000 - Gerber/CAM Software 1028

Online Support and FAQ for FAB 3000.

S
How do I insert components on the bottom side?
Posted by Simon Garrison, about 3 years ago
S
I find it sometimes confusing when I can see a file in the job list, but it is hashed out, so not accessible.
Posted by Simon Garrison, about 3 years ago , Last Reply by Simon Garrison about 3 years ago
S
Can I create a drill table, where the software counts all of my drills and creates a table like this for my panel?
Posted by Simon Garrison, about 3 years ago
D
Pads at unusual angles
Posted by Dave LeMat, about 3 years ago
S
Gerber Layer Types are not all correctly detected in the Auto Load dialog. I am using the command (menu: File / Import / AutoLoad...)
Posted by Simon Garrison, about 3 years ago
S
We need a separate routing layer for the panel outline itself. How can I accomplish this?
Posted by Simon Garrison, about 3 years ago
S
I used DFM Now, and I sometimes want to compare two gerber file sets. Is that possible in the free software?
Posted by Stefan.althoefer, about 3 years ago
S
Export slots on drill file
Posted by Salvador Mendoza, about 3 years ago
N
Selection Filter and Teardrops.
Posted by Numerical Support Team, over 13 years ago , Last Reply by Simon Garrison about 3 years ago
S
Is there a way to select all the silkscreen under my selected parameters and then change propieties?
Posted by Simon Garrison, about 3 years ago , Last Reply by Simon Garrison about 3 years ago