How can we help you today?

Start a new topic
Discussions ACE Translator 3000 (CAD to EDA Translator)
ACE Translator 3000 (CAD to EDA Translator) 333

Online Support and FAQ

S
When performing a 3D STEP conversion, I do not see the option to setup the Z-base, as demonstrated in your Youtube videos. Am I using the wrong version?
Posted by Simon Garrison, 3 months ago , Last Reply by Simon Garrison 3 months ago
S
I noticed that my drill file (.drl) has other dimension (mm) than my other gerber files mainly all the other layer files (mil). I can successfully convert the gerber files to ODB++with only one exception; that is my drill "layer" does not match properly.
Posted by Simon Garrison, 4 months ago
S
I converted a batch of gerber files to a step file, but they all were put on the same layer/plane. How can I manipulate it to show them on a 3D board?
Posted by Simon Garrison, 5 months ago
S
Converting a COMSOL STEP to Gerber for PCB Manufacturing.
Posted by Simon Garrison, 6 months ago
S
First for the segment file, you can see some of the yellow lines are composed of two separate segments that don’t quite overlap. Is there a way to get these to join together and round out?
Posted by Simon Garrison, 7 months ago , Last Reply by Simon Garrison 7 months ago
S
During DXF to Gerber conversion, my drill file is empty because the drill holes are in a mode where they are painted, our CAM station calls them contours (by drawing the perimeter of the circle and shading it in.)
Posted by Simon Garrison, 8 months ago
j
Large image file (TIF, PNG)
Posted by julio portillo, 8 months ago
S
Yes here is a sample I made into BMP from a DWG file with the ACE converter. However this one has not been accepted by the dimatix printers file formatting system, can you help?
Posted by Simon Garrison, 11 months ago
S
When exporting Gerber files from ACE, do you happen to have function for negative/reverse Gerber?
Posted by Simon Garrison, 11 months ago
S
There is a 'Save current Layer Map to a file' button but I could not locate the saved file and check its format.
Posted by Simon Garrison, 12 months ago